3Com 8800 Configuration Manual page 693

3Com Switch 8800 Configuration Guide
1) Enabling info-center
Perform the following configuration in system view.
Table 46-34 Enable/disable info-center
Enable info-center
Disable info-center
Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
2) Configuring to output information to the log buffer
Perform the following configuration in system view.
Table 46-35 Configure to output information to log buffer
Output information to log buffer
Cancel
outputting information to log buffer
3) Configuring information source on the switch
By this configuration, you can define the information that sent to log buffer is generated
by which modules, information type, information level, and so on.
Perform the following configuration in system view:
Table 46-36 Define information source
Define information source
Cancel the configuration of
information source
Operation
Operation
the configuration
Operation
info-center source { modu-name | default }
channel { channel-number | channel-name } [ debug
{ level severity | state state }* | log { level severity |
state state }* | trap { level severity | state state }* ]*
undo info-center source { modu-name | default |
all } channel { channel-number | channel-name }
Chapter 46 System Maintenance and Debugging
info-center enable
undo info-center enable
info-center logbuffer
{ channel-number | channel-name } | size
buffersize ]*
of
undo info-center logbuffer [ channel | size ]
Command
46-22
Command
Command
[ channel