Setting Timers Regarding Tacacs Server - 3Com 8800 Configuration Manual

3com 8800: install guide
Hide thumbs Also See for 8800:
Table of Contents

Advertisement

3Com Switch 8800 Configuration Guide

40.4.9 Setting Timers Regarding TACACS Server

I. Setting the response timeout timer
Since TACACS+ is implemented on the basis of TCP, server response timeout or TCP
timeout may terminate the connection to the TACACS server.
Perform the following configuration in TACACS+ view.
Table 40-35 Set the response timeout timer
Set the response timeout time
Restore the default setting
The default response timeout timer is set to 5 seconds.
II. Setting the quiet timer for the primary TACACS server
Perform the following configuration in TACACS+ view.
Table 40-36 Set the quiet timer for the primary TACACS server
Set the quiet timer for the primary TACACS server
Restore the default setting
The timer quiet command is used to make the switch ignore users' requests for server
within the time configured in this command in case the communication between the
switch and the server is terminated. In that case, the switch can send users' requests to
the server only after it has waited a time no less than the time configured with this
command for the communication to be resumed.
By default, the primary TACACS server must wait five minutes before it can resume the
active state. The time ranges from 1 to 255.
III. Setting a realtime accounting interval
The setting of real-time accounting interval is necessary to real-time accounting. After
an interval value is set, the NAS transmits the accounting information of online users to
the TACACS accounting server periodically.
Perform the following configuration in TACACS+ view.
Chapter 40 AAA and RADIUS/TACACS+ Protocol Con
Operation
Operation
40-28
Command
timer response-timeout seconds
undo timer response-timeout
Command
timer quiet minutes
undo timer quiet
figuration

Advertisement

Table of Contents
loading

Table of Contents