Displaying And Debugging Ha Configuration - 3Com 8800 Configuration Manual

3com 8800: install guide
Hide thumbs Also See for 8800:
Table of Contents

Advertisement

3Com Switch 8800 Configuration Guide
Caution:
When a single Fabric is in position, the load-balance mode is not effective and the
Fabric changes to the load-single mode automatically.

42.3 Displaying and Debugging HA Configuration

After the above configuration, execute display command in relevant view to display the
running of the ACL configuration, and to verify the configuration. Execute debugging
command in user view to enable HA module debugging function.
Perform the following configuration in relevant view.
Table 42-6 Display and debug HA configuration
Display the status of the Fabric and
slave board(any view)
Display the load mode of the Fabric and
slave board(system view)
Enable
output of the HA module(user view)
Disable
output of the HA module(user view)
Operation
the
debugging
information
the
debugging
information
display switchover state [ slot-id ]
display xbar
debugging ha { all | event | message |
state }
undo debugging ha { all | event |
message | state }
42-4
Chapter 42 HA Configuration
Command

Advertisement

Table of Contents
loading

Table of Contents