Configuring Med For As; Comparing The Med Routing Metrics From The Peers In Different Ass - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
By default, the local preference is 100.

21.2.13 Configuring MED for AS

Multi-Exit Discriminators (MED) attribute is the external metric for a route. AS uses the
local preference to select the route to the outside, and uses the MED to determine the
optimum route for entering the AS. When a router running BGP gets routes with the
same destination address but different next hops through different external peers, it will
select the route of the smallest MED as the optimum route, provided that all the other
conditions are the same.
Perform the following configuration in BGP view.
Table 21-33 Configure an MED metric for the system
Configure an MED metric for the system
Restore the default MED metric of the system
By default, MED metric is 0.
The router configured above only compares the route MED metrics of different EBGP
peers in the same AS. Using the compare-different-as-med command, you can
compare the route MED metrics of the peers in different ASs.

21.2.14 Comparing the MED Routing Metrics from the Peers in Different ASs

It is used to select the best route. The route with smaller MED value will be selected.
Perform the following configuration in BGP view.
Table 21-34 Compare the MED routing metrics from the peers in different ASs
Compare the MED routing metrics from the
peers in different ASs
Configure not to compare the MED routing
metrics from the peers in different ASs
By default, MED comparison is not allowed among the routes from the neighbors in
different ASs.
It is not recommended to use this configuration unless you can make sure that the ASs
adopt the same IGP and routing method.
Operation
Operation
21-20
Chapter 21 BGP Configuration
Command
default med med-value
undo default med
Command
compare-different-as-med
undo compare-different-as-med