Displaying And Maintaining Link Aggregation - 3Com 4510G Configuration Manual

To do...
Configure the global link
aggregation load sharing
mode
Configuring a load sharing mode for a link aggregation group
Follow these steps to configure a load sharing mode specific to a link aggregation group:
To do...
Enter system view
Enter Layer 2 aggregate
interface view
Configure the load
sharing mode for the
aggregation group

Displaying and Maintaining Link Aggregation

To do...
Display the local system ID
Display the global or
aggregation group-specific
load sharing mode
Display link aggregation details
of ports
Display the summary
information of all aggregation
groups
Use the command...
link-aggregation load-sharing mode
{ destination-ip | destination-mac |
destination-port | ingress-port |
source-ip | source-mac |
source-port } *
Use the command...
system-view
interface bridge-aggregation
interface-number
link-aggregation load-sharing mode
{ destination-ip | destination-mac |
source-ip | source-mac } *
Use the command...
display lacp system-id
display link-aggregation
load-sharing mode [ interface
[ bridge-aggregation
interface-number ] ]
display link-aggregation
member-port [ interface-type
interface-number [ to interface-type
interface-number ] ]
display link-aggregation
summary
2-10
Remarks
Optional
By default, the hash keys
for Layer 2 packets are
source/destination MAC
addresses, and those for
Layer-3 packets are
source/destination IP
addresses.
After you configure this
command, the load
sharing modes in all link
aggregation groups
change accordingly
Remarks
—
—
Required
By default, the load
sharing mode of an
aggregation group is the
global load sharing mode.
After you configure this
command, the load
sharing modes in current
link aggregation group
change accordingly.
Remarks
Available in any view
Available in any view
Available in any view
Available in any view