Displaying And Debugging The Routing Policy - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
Table 22-9 Configure to filter the advertised routes
Configure to filter the routes
advertised by the protocol
Cancel the filtering of the routes
advertised by the protocol
By far, the route policy supports importing the routes discovered by the following
protocols into the routing table:
direct: The hop (or host) to which the local interface is directly connected.
static: Route configured statically
rip: Route discovered by RIP
ospf: Route discovered by OSPF
ospf-ase: External route discovered by OSPF
ospf-nssa: NSSA route discovered by OSPF
isis: Route discovered by IS-IS
bgp: Route acquired by BGP
By default, the filtering of the received and advertised routes will not be performed.

22.3 Displaying and Debugging the Routing Policy

After the above configuration, execute the display command in any view to display the
running of the routing policy configuration, and to verify the effect of the configuration.
Table 22-10 Display and debug the route policy
Display the routing policy
Display the path information of the AS
filter in BGP
Display
information
Operation
Operation
the address prefix
22-10
Chapter 22 IP Routing Policy Configuration
Command
filter-policy { acl-number
ip-prefix-name } export [ protocol ]
undo filter-policy { acl-number | ip-prefix
ip-prefix-name } export [ protocol ]
Command
display
[ route-policy-name ]
display ip as-path-acl [ acl-number ]
list
display ip ip-prefix [ ip-prefix-name ]
| ip-prefix
route-policy