Chapter 6 Ethernet Port Configuration; Ethernet Port Overview; Ethernet Port Configuration; Entering Ethernet Port View - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide

Chapter 6 Ethernet Port Configuration

6.1 Ethernet Port Overview

The Switch 8800 provides conventional Ethernet ports, fast Ethernet ports, 1000 Mbps
Ethernet ports and 10 Gbps Ethernet ports. The configurations of these Ethernet ports
are basically the same, which will be described in the following sections.

6.2 Ethernet Port Configuration

The following sections describe Ethernet port configuration tasks:

Entering Ethernet Port View

Enabling/Disabling an Ethernet Port
Setting Ethernet Port Description
Setting the Duplex Attribute of the Ethernet Port
Setting Speed on the Ethernet Port
Setting the Cable Type for the Ethernet Port
Enabling/Disabling Flow Control for the Ethernet Port
Permitting/Forbidding Jumbo Frame to Pass the Ethernet Port
Setting the Ethernet Port Broadcast Suppression Ratio
Setting the Ethernet Port Mode
Setting the Link Type for the Ethernet Port
Adding the Ethernet Port to Specified VLANs
Setting the Default VLAN ID for the Ethernet Port
Setting the VLAN VPN Feature
Copying Port Configuration to Other Ports
Setting Port Hold Time
Setting the Ethernet Port in Loopback Mode
6.2.1 Entering Ethernet Port View
Before configuring the Ethernet port, enter Ethernet port view first.
Perform the following configuration in system view.
Table 6-1 Enter Ethernet port view
Enter Ethernet port view
Operation
6-1
Chapter 6 Ethernet Port Configuration
Command
interface { interface_type interface_num |
interface_name }