Poe Configuration Tasks - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
Table 51-1 PoE configuration tasks on the Switch 8800
No
Enter
1
view
Enter
2
port view
Enable PoE on
3
the port
Set the maximum
PoE
4
supplied by the
port
Set
5
mode on the port
Set
6 priority
port
Display the PoE
state of a specific
7
or all ports of the
switch
Display the PoE
power
information of a
8
specific
ports
switch
Display the PoE
status and PoE
9 power
information
each card
Item Command
system
system-view
Ethernet interface
interface-number
poe enable
power poe
max-power
the PoE poe mode { signal |
spare | auto }
the PoE
poe priority { critical |
on the
high | low }
display
[ interface-name
interface-type
interface-num ]
display
power [ interface-name |
or all interface-type
of the interface-num ]
display poe pse
of
51-3
Chapter 51 PoE Configuration
—
As
command, a port view
interface-type
prompt is displayed, which
varies with the port type
you selected.
By default, PoE is disabled
on a port.
You can set the maximum
PoE power supplied by a
max-power port depending on the
power of the actual PD. By
default, the max-power is
16800 mW.
The Switch 8800 supports
only signal line PoE mode.
By default, the PoE mode
on a port is signal.
You can set the PoE
priority
depending on the practical
situation. By default, the
PoE priority on a port is
low.
You
command in any view.
poe interface
Executing the display poe
|
interface
without any option displays
the PoE status of all the
ports.
You
command in any view.
poe interface Executing the display poe
interface
command
option displays the PoE
power information about
all the ports.
You
command in any view
Description
a result of this
on a port
can execute this
command
can execute this
power
without any
can execute this