Displaying And Debugging Static Route; Typical Static Route Configuration Example - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide

17.3 Displaying and Debugging Static Route

After the above configuration, execute the display command in any view to display the
running of the static route configuration, and to verify the effect of the configuration.
Table 17-4 Display and debug the routing table
Display routing table summary
Display routing table details
Display the detailed information of a
specific route
Display the route information in the
specified address range
Display the route filtered through the
specified basic access control list (ACL)
Display the route information that is
filtered through the specified ip prefix list
Display
discovered by the specified protocol
Display the tree routing table
Display the statistics of the routing table
Display the routing information about the
VPN instance

17.4 Typical Static Route Configuration Example

I. Network requirements
As shown in Figure 17-1, the masks of all the IP addresses are 255.255.255.0. It is
required that all the hosts or the Switch 8800 can be interconnected in pairs by static
route configuration.
Operation
the routing information
Chapter 17 Static Route Configuration
display ip routing-table
display ip routing-table verbose
display ip routing-table ip_address
[ mask ] [ longer-match ] [ verbose ]
display ip routing-table ip_address1
mask1 ip_address2 mask2 [ verbose ]
display
{ acl-number | acl-name } [ verbose ]
display ip
ip-prefix-number [ verbose ]
display ip
protocol [ inactive | verbose ]
display ip routing-table radix
display ip routing-table statistics
display ip routing-table vpn-instance
vpn-instance-name
17-4
Command
ip routing-table
routing-table ip-prefix
routing-table protocol
acl