3Com 8800 Configuration Manual page 361

3Com Switch 8800 Configuration Guide
By default, there is no route reflector in an AS.
It is generally unnecessary to configure this command for a peer group. This command
is reserved for the occasional compatibility with the network equipments of other
vendors.
VI. Configuring the local address as the next hop when advertising routes
This involves removing the next hop configuration in the routing information advertised
to a peer (group) and configuring the local address as the next hop address. It is valid
only for IBGP peers/peer groups.
Please perform the following configurations in IPV4 multicast sub-address family view.
Table 31-7 Configuring the local address as the next hop when advertising routes
Configure the local address as the next
hop
information
Remove the above configuration
VII. Specifying the routing policy for a peer (group)
Please perform the following configurations in IPV4 multicast sub-address family view.
Table 31-8 Specifying the routing policy for a peer (group)
Configure routing policy for
incoming packets
Remove
cnfiguration
Configure routing policy for
outgoing packets
Remove
cnfiguration
By default, no routing policy is specified for any peer (group).
VIII. Configuring IP-ACL-based route filtering policy for a peer (group)
Please perform the following configurations in IPV4 multicast sub-address family view.
Operation
when advertising
Operation
incoming policy
outgoing policy
Chapter 31 MBGP Multicast Extension Configuration
routing peer group-name next-hop-local
undo peer group-name next-hop-local
Command
peer { group-name | peer-address } route-policy
policy-name import
undo peer { group-name | peer-address }
route-policy policy-name import
peer group-name route-policy policy-name
export
undo peer group-name
policy-name export
31-7
Command
route-policy