Setting The Summer Time; Displaying The State And Information Of The System - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
Table 46-3 Set the time zone
Set the local time
Restore to the default UTC time zone
By default, the UTC time zone is adopted.

46.1.4 Setting the Summer Time

You can set the name, starting and ending time of the summer time.
Perform the following configuration in user view.
Table 46-4 Set the summer time
Set the name and range of the summer
time
Remove the setting of the summer time
By default, the summer time is not set.

46.2 Displaying the State and Information of the System

The switch provides the display command for displaying the the system state and
statistics information.
For the display commands related to each protocols and different ports, refer to the
relevant chapters. The following display commands are used for displaying the system
state and the statistics information.
Perform the following operations in any view.
Table 46-5 The display commands of the system
Display the system clock
Display the system version
Display the state of the debugging
Operation
Operation
Operation
46-2
Chapter 46 System Maintenance and Debugging
Command
clock timezone zone_name { add |
minus } HH:MM:SS
undo clock timezone
Command
clock summer-time
{ one-off | repeating } start-time
start-date end-time end-date offset-time
undo clock summer-time
Command
display clock
display version
display debugging
{ interface-name
interface-number } ] [ module-name ]
zone_name
[ interface
| interface-type