Setting The Username Format Transmitted To Radius Server; Setting The Unit Of Data Flow That Transmitted To Radius Server - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide

40.3.13 Setting the Username Format Transmitted to RADIUS Server

As mentioned above, the supplicants are generally named in userid@isp-name format.
The part following "@" is the ISP domain name. The Switch 8800 will put the users into
different ISP domains according to the domain names. However, some earlier RADIUS
servers reject the username including ISP domain name. In this case, you have to
remove the domain name before sending the username to the RADIUS server. The
following command of switch decides whether the username to be sent to RADIUS
server carries ISP domain name or not.
Perform the following configuration in RADIUS scheme view.
Table 40-23 Set the username format transmitted to RADIUS server
Set Username Format Transmitted to
RADIUS Server
Note:
If a RADIUS scheme is configured not to allow usernames including ISP domain names,
the RADIUS scheme shall not be simultaneously used in more than one ISP domain.
Otherwise, the RADIUS server will regard two users in different ISP domains as the
same user by mistake, if they have the same username (excluding their respective
domain names.)
By default, as for the newly created RADIUS scheme, the username sent to RADIUS
servers includes an ISP domain name; as for the "system" RADIUS scheme created by
the system, the username sent to RADIUS servers excludes the ISP domain name.

40.3.14 Setting the Unit of Data Flow that Transmitted to RADIUS Server

The following command defines the unit of the data flow sent to RADIUS server.
Perform the following configuration in RADIUS scheme view.
Table 40-24 Set the unit of data flow transmitted to RADIUS server
Set the unit of data flow transmitted to
RADIUS server
Restore the unit to the default setting
Chapter 40 AAA and RADIUS/TACACS+ Protocol Con
Operation
Operation
40-21
Command
user-name-format { with-domain |
without-domain }
Command
data-flow-format data
giga-byte | kilo-byte | mega-byte }
packet { giga-byte | kilo-byte |
mega-byte | one-packet }
undo data-flow-format
figuration
{ |
byte