Displaying And Debugging Snmp; Snmp Configuration Example - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide

47.4 Displaying and Debugging SNMP

After the above configuration, execute the display command in any view to display the
running of the SNMP configuration, and to verify the effect of the configuration.
Table 47-14 Display and debug SNMP
Display the statistics information about
SNMP packets
Display the engine ID of the active
device
Display the group name, the security
mode, the states for all types of views,
and the storage mode of each group of
the switch.
Display SNMP user information in the
group user table
Display the current community name
Display the current MIB view
Display the contact character strings,
location character strings, and the
SNMP version of the system

47.5 SNMP Configuration Example

I. Network requirements
Network Management Station and the Ethernet switch are connected through the
Ethernet. The IP address of Network Management Station is 129.102.149.23 and that
of the VLAN interface on the switch is 129.102.0.1. Perform the following configurations
on the switch: setting the community name and access authority, administrator ID,
contact and switch location, and enabling the switch to send trap packets.
Operation
47-9
Chapter 47 SNMP Configuration
Command
display snmp-agent statistics
display snmp-agent { local-engineid |
remote-engineid }
display snmp-agent
[ group-name ]
display snmp-agent
[ engineid engineid | group groupname
| username username ]*
display snmp-agent
[ read | write ]
display snmp-agent
[ exclude | include | { viewname
mib-view } ]
display snmp-agent sys-info [ contact
| location | version ]*
group
usm-user
community
mib-view