3Com 8800 Configuration Manual page 377

3Com Switch 8800 Configuration Guide
The fragment-flags field is 0 in length in flow template, so it can be ignored in
calculating the total length of template elements.
You can either use the default template or define a flow template based on your needs.
Note:
Default flow template:
ip-protocol tcp-flag sport dport icmp-type icmp-code sip 0.0.0.0 dip 0.0.0.0
You cannot modify or delete the default flow template.
II. Applying Flow Template
Perform the following configurations in Ethernet port view or port group view to apply
the user-defined flow template to current port or current port group.
Table 32-7 Apply flow template
Apply the user-defined flow template
Cancel the applied flow template
32.2.3 Defining ACL
The switch supports several types of ACLs, which are described in this section.
Follow these steps to define an ACL
1) Enter the corresponding ACL view
2) Define ACL rules
Operation
32-7
Chapter 32 ACL Configuration
Command
flow-template user-defined
undo flow-template user-defined