Clearing The Configuration Information Of The Dhcp Server; Dhcp Server Configuration Example - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
Display the information about IP address
binding in DHCP address pool(s)
Display the statistics about the DHCP
server
Display the information about the
tree-like structure of DHCP address
pool(s)
Perform the following configuration in user view.
Table 13-31 Enable/Disable debugging for the DHCP server
Disable debugging for the DHCP server
Enable debugging for the DHCP server

13.3.13 Clearing the Configuration Information of the DHCP Server

You can clear the configuration information of the DHCP server by executing the reset
command in user view.
Perform the following configuration in user view.
Table 13-32 Clear the configuration information of the DHCP server
Clear the statistics about DHCP address
conflicts
Clear the information about dynamically
bound DHCP addresses
Clear the statistics about the DHCP
server

13.3.14 DHCP Server Configuration Example

I. Network requirements
As shown in Figure 13-2, two DHCP clients at the same network segment (10.110.0.0)
are connected to the following switch through a port in VLAN2. The switch, acting as a
Operation
Operation
Operation
13-19
Chapter 13 DHCP Configuration
Command
display dhcp server ip-in-use { ip
ip-address | pool [ pool-name ] |
interface [ vlan-interface vlan_id ] | all }
display dhcp server statistics
display dhcp server tree { pool
[ pool-name ]
[ vlan-interface vlan_id ] | all }
Command
undo debugging dhcp server { all |
error | event | packet }
debugging dhcp server { all | error |
event | packet }
Command
reset dhcp server conflict { ip
ip-address | all }
reset dhcp server ip-in-use{ all |
interface [ vlan-interface vlan_id ] | ip
ip-address | pool [ pool-name ] }
reset dhcp server statistics
| interface