Resetting All The Is-Is Data Structure; Resetting The Specified Is-Is Peer; Displaying And Debugging Integrated Is-Is - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
The silent-interface command is only used to restrain the IS-IS packets not to be sent
on the interface, but the interface routes can still be sent from other interfaces. On a
switch, this command can disable/enable the specified VLAN interface to send IS-IS
packets.

20.2.25 Resetting All the IS-IS Data Structure

When it is necessary to refresh some LSPs immediately, perform the following
configuration in user view.
Table 20-34 Reset all the IS-IS data structures
Reset the IS-IS data structure
By default, the IS-IS data structure is not cleared.

20.2.26 Resetting the Specified IS-IS Peer

When it is necessary to connect a specified peer again, perform the following
configuration in user view.
Table 20-35 Reset the specified IS-IS peer
Reset the specified IS-IS peer
By default, the IS-IS peer is not cleared.

20.3 Displaying and Debugging Integrated IS-IS

After completing the above configuration, execute the display command in any view to
display the running state of the IS-IS configuration, and to verify the effect of the
configuration. Execute the debugging command in user view to debug the IS-IS
module.
Through the following configuration operations, you can view the LSDB of the IS-IS, the
transmitting/receiving of various packets of the IS-IS and the SPF calculation so as to
determine the IS-IS route maintenance conditions.
Table 20-36 Display and debug IS-IS
Display IS-IS LSDB
Operation
Operation
Operation
20-24
Chapter 20 Integrated IS-IS Configuration
Command
reset isis all
Command
reset isis peer system-id
Command
display isis lsdb [ [ l1 | l2 | level-1 | level-2 ] |
[ [ LSPID | local ] | verbose ]* ]*