Creating/Deleting A Local User - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
Once this function is enabled on the switch, users can locate the self-service server
through the following operations:
Select "Change user password" on the 802.1x client.
After the client opens the default explorer (IE or NetScape), locate the specified
URL page used to change the user password on the self-service server.
Change user password on this page.
Perform the following configuration in ISP domain view.
Table 40-4 Configure the self-service server URL
Configure self-service server URL and configure the
URL address used to change the user password on the
self-service server
Remove the configuration of self-service server URL
By default, self-service server URL is not configured on the switch.
Note that, if "?" is contained in the URL, you must replace it with "|" when inputting the
URL in the command line.
The "Change user password" option is available only when the user passes the
authentication; otherwise, this option is in grey and unavailable.

40.2.4 Creating/Deleting a Local User

A local user is a group of users set on NAS. The username is the unique identifier of a
user. A supplicant requesting network service may use local authentication only if its
corresponding local user has been added onto NAS.
Perform the following configuration in system view.
Table 40-5 Create/Delete a local user
Add a local user
Delete all the local users
Delete a local user by specifying
its type
By default, there is no local user in the system.
Operation
Operation
Chapter 40 AAA and RADIUS/TACACS+ Protocol Con
Command
local-user user-name
undo local-user all
undo local-user
[ service-type { lan-access | ftp | telnet | ppp |
ssh | terminal } ] }
40-9
figuration
Command
self-service-url enable
url-string
self-service-url disable
{ |
user-name all