Configuring The Source Address For Tacacs+ Packets Sent By Nas; Setting A Key For Securing The Communication With Tacacs Server - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
Table 40-30 Configure stop-accounting packet retransmission
Enable stop-accounting packet retransmission and
set the allowed maximum number of transmission
attempts
Disable stop-accounting packet retransmission
Clear the stop-accounting request packets that
have no response
By default, stop-accounting packet retransmission is enabled, and the maximum
number of transmission attempts is 300.

40.4.5 Configuring the Source Address for TACACS+ Packets Sent by NAS

Perform the following configuration in the corresponding view.
Table 40-31 Configure the source address for TACACS+ packets sent by the NAS
Configure the source address for TACACS+ packets sent
from the NAS (TACACS+ view)
Delete the configured source address for TACACS+
packets sent from the NAS (TACACS+ view)
Configure the source address for TACACS+ packets sent
from the NAS (System view)
Cancel the configured source address for TACACS+
packets sent from the NAS (System view)
The TACACS+ view takes precedence over the system view when configuring the
source address for TACACS+ packets sent from the NAS.
By default, the source address is not specified, and the virtual interface of the VLAN
that contains the port to which the server connects for packet sending is used as the
source address.

40.4.6 Setting a Key for Securing the Communication with TACACS Server

When using a TACACS server as an AAA server, you can set a key to improve the
communication security between the switch and the TACACS server.
Perform the following configuration in TACACS+ view.
Chapter 40 AAA and RADIUS/TACACS+ Protocol Con
Operation
Operation
40-26
Command
retry stop-accounting
retry-times
undo retry stop-accounting
reset
stop-accounting-buffer
TACACS+-scheme
TACACS+-scheme-name
Command
nas-ip ip-address
undo nas-ip
TACACS+
ip-address
undo TACACS+
nas-ip
figuration
nas-ip