3Com Switch 8800 Configuration Guide
Table 36-5 Enable/disable LDP view
Enable LDP protocol
Disable LDP
By default, LDP is disabled.
36.3.2 Enabling LDP on VLAN interface
To make the VLAN interface support LDP, you must enable LDP function on virtual
interface in VLAN interface mode. After enabling the LDP function, the virtual interface
then sets up session. It begins to set up LSP if in topology-driven mode,.
Disabling LDP function on interface causes the break of all LDP session in VLAN
interface, and all the LSP based on those sessions are deleted. So you must use this
command with cautiously.
Perform the following configuration in the interface view.
Table 36-6 Enable/disable LDP on interface
Enable LDP function on interface
Disable LDP function on interface
By default, the interface LDP function is disabled.
36.3.3 Configuring Remote-Peer for Extended Discovery Mode
The remote-peer configuration is mainly used for extended discovery mode so that this
LSR can establish sessions with LSRs that are not directly connected with it at the link
layer.
I. Create a remote-peer
Perform the following configuration in the system view.
Table 36-7 Create a remote-peer
Create
remote-peer view
Delete the corresponding remote-peer
Operation
Operation
Operation
a
remote-peer
and
Chapter 36 MPLS Basic Capability Configuration
mpls ldp
undo mpls ldp
mpls ldp enable
mpls ldp disable
enter
mpls ldp remote-peer index
undo mpls ldp remote-peer index
36-4
Command
Command
Command