Pim-Dm Configuration Example - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
Table 28-9 Displaying and debugging PIM-DM
Display the PIM multicast routing table
Display the PIM interface information
Display the information about PIM
neighboring routers
Display BSR information
Display RP information
Enable the PIM debugging
Disable the PIM debugging
Enable the PIM-DM debugging
Disable the PIM-DM debugging

28.4 PIM-DM Configuration Example

I. Networking requirements
Lanswitch1 is connected to the multicast source through VLAN-interface 10, connected
to Lanswitch2 through VLAN-interface 11 and connected to Lanswitch3 through
VLAN-interface 12. Through running PIM-DM, you can implement multicast among
RECEIVER 1, RECEIVER 12 and Multicast Source.
II. Networking diagram
Operation
28-7
Chapter 28 PIM-DM Configuration
Command
display pim routing-table [ { { *g
[ group-address [ mask { mask-length |
mask } ] ] | **rp [ rp-address [ mask
{ mask-length | mask } ] ] } |
{ group-address [ mask { mask-length |
mask } ] | source-address [ mask
{ mask-length | mask } ] } * } |
incoming-interface { Vlan-interface
Vlan-interface-number
{ dense-mode | sparse-mode } ] *
display pim interface [ Vlan-interface
Vlan-interface-number ]
display pim neighbor [ interface
Vlan-interface Vlan-interface-number ]
display pim bsr-info
display pim rp-info [ group-address ]
debugging pim common { all | event |
packet | timer }
undo debugging pim common { all |
event | packet | timer }
debugging pim dm { alert | all | mbr |
mrt | timer | warning | { recv | send }
{ all | assert | graft | graft-ack | join |
prune } }
undo debugging pim dm { alert | all |
mbr | mrt | timer | warning | { recv |
send } { all | assert | graft | graft-ack |
join | prune } }
| null } |