Displaying And Debugging User Interface - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
Table 4-21 Configure to automatically run the command
Configure to automatically run the command
Configure not to automatically run the
command
Note the following points:
After executing this command, the user interface can no longer be used to carry
out the routine configurations for the local system. Use this command with caution.
Make sure that you will be able to log in the system in some other way and cancel
the configuration, before you use the auto-execute command command and
save the configuration.
Telnet 10.110.100.1 after the user logs in through VTY0 automatically.
[SW8800-ui-vty0] auto-execute command telnet 10.110.100.1
When a user logs on via VTY 0, the system will run telnet 10.110.100.1 automatically.

4.3 Displaying and Debugging User Interface

After the above configuration, execute display command in any view to display the
running of the user interface configuration, and to verify the effect of the configuration.
Execute free command in user view to clear a specified user interface.
Table 4-22 Display and debug user interface
Clear a specified user interface
Display the user application information
of the user interface
Display the physical attributes and some
configurations of the user interface
Operation
Operation
4-11
Chapter 4 User Interface Configuration
Command
auto-execute command text
undo auto-execute command
Command
free user-interface [ type ] number
display users [ all ]
display user-interface [ type number |
number ] [ summary ]