3Com 8800 Configuration Manual page 689

3Com Switch 8800 Configuration Guide
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
Note:
If you want to view the debugging information of some modules on the switch, you must
select debugging as the information type when configuring information source,
meantime using the debugging command to turn on the debugging switch of those
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
This configuration will affect the timestamp of the displayed ifnormation.
Perform the following configuration in system view:
Table 46-27 Configure the output format of time-stamp
Configure the output format of the
time-stamp
Output time-stamp is disabled
4) Enable terminal display function
To view the output information at the console terminal, you must first enable the
corresponding log, debugging and trap information functions at the switch.
For example, if you have set the log information as the information sent to the console
terminal, now you need to use the terminal logging command to enable the terminal
display function of log information on the switch, then you can view the information at
the console terminal.
Perform the following configuration in user view:
Table 46-28 Enable terminal display function
Enable terminal display function of debugging
information
Disable terminal display function of debugging
information
Enable terminal display function of log information
Disable terminal display function of log information
Operation
Operation
46-18
Chapter 46 System Maintenance and Debugging
Command
info-center timestamp { log | trap |
debugging } { boot | date | none }
undo info-center timestamp { log |
trap | debugging }
terminal debugging
undo terminal debugging
terminal logging
undo terminal logging
Command