3Com Switch 8800 Configuration Guide
47.3.8 Setting the Source Address of Trap
You can use the following commands to set or remove the source address of the trap.
Perform the following configuration in system view.
Table 47-9 Set the source address of trap
Set the Source Address of Trap
Remove the source address of trap
Note:
Currently, this command takes effect only on the interfaces with vlan-interface type.
47.3.9 Adding/Deleting a User to/from an SNMP Group
You can use the following commands to add or delete a user to/from an SNMP group.
Perform the following configuration in system view.
Table 47-10 Add/Delete a user to/from an SNMP group
Add a user to an SNMP group.
Delete a user from an SNMP
group.
You must first configure the SNMP engine ID before configuring the remote user for an
agent, because the engine ID is required during the authentication. If you forget to
configure the engine ID before adding a user, the operation of adding this user will fail.
For SNMP V1 and V2c, this operation is adding a new community name, while for
SNMP V3, this operation is adding a user for an SNMP group.
Operation
Operation
Chapter 47 SNMP Configuration
snmp-agent trap source interface-name
interface-num
undo snmp-agent trap source
Command
snmp-agent usm-user { v1 | v2c } username
groupname [ acl acl-list ]
snmp-agent usm-user v3 username groupname
[
authentication-mode
authpassstring
[
privpassstring } ] ] [ acl acl-list ]
undo snmp-agent usm-user { v1 | v2c }
username groupname
undo snmp-agent usm-user v3 username
groupname { local | engineid engine-id }
47-7
Command
{
md5
|
sha
privacy-mode
{
}
des56