Setting Maximum Local Sessions; Displaying And Debugging Ntp - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
server: Allow local NTP time service request and control query. However, the local
clock will not be synchronized by a remote server.
peer: Allow local NTP time service request and control query. And the local clock will
also be synchronized by a remote server.

49.2.8 Setting Maximum Local Sessions

This configuration task is to set the maximum local sessions.
Perform the following configurations in system view.
Table 49-13 Set the maximum local sessions
Set the maximum local sessions
Resume the maximum number of local
sessions
number specifies the maximum number of local sessions, ranges from 0 to 100, and
defaults to 100.

49.3 Displaying and Debugging NTP

After completing the above configurations, you can use the display command to show
how NTP runs and verify the configurations according to the outputs.
In user view, you can use the debugging command to debug NTP.
Table 49-14 Display and debug NTP
Display the status of NTP service
Display the status of sessions maintained by
NTP service
Display the brief information about every NTP
time server on the way from the local
equipment to the reference clock source.
Enable NTP debugging
Operation
Operation
49-9
Chapter 49 NTP Configuration
Command
ntp-service max-dynamic-sessions
number
undo
max-dynamic-sessions
Command
display ntp-service status
display ntp-service
[ verbose ]
display ntp-service trace
debugging ntp-service
ntp-service
sessions