Sending The Configuration Information To The Loghost - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
Network
management
workstation

46.5.3 Sending the Configuration Information to the Loghost

To send configuration information to the loghost, follow the steps below:
1) Enabling info-center
Perform the following configuration in system view.
Table 46-20 Enable/disable info-center
Enable info-center
Disable info-center
Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
2) Configuring to output information to the loghost
Perform the following configuration in system view.
Set the
information
—
output direction
to SNMP
Set information
—
source
Configure
—
SNMP features
The same as the
SNMP
—
configuration of
the switch
Operation
46-14
Chapter 46 System Maintenance and Debugging
—
You can
modules and information to be
sent out and the time-stamp
format of information, and so
on. You must turn on the
switch of the corresponding
module before defining output
debugging information.
Refer to Chapter 47 SNMP
Configuration
—
Command
info-center enable
undo info-center enable
define which