Currently, when you configure the load sharing criterion or criteria for a link aggregation group, the
switch supports the following criteria:
Use a source IP address alone.
Use a destination IP address alone.
Use a source MAC address alone.
Use or a destination MAC address alone.
Combine a source IP address and a destination IP address.
Combine a destination MAC address and a source MAC address.
Displaying and Maintaining Ethernet Link Aggregation
To do...
Display the local system ID
Display the global or
group-specific link-aggregation
load sharing criteria
Display detailed link
aggregation information on link
aggregation member ports
Display the summary of all
aggregation groups
Display detailed information
about a specific or all
aggregation groups
Clear LACP statistics for a
specific or all link aggregation
member ports
Clear statistics for a specific or
all aggregate interfaces
Ethernet Link Aggregation Configuration Examples
In an aggregation group, only ports that have the same port attributes and class-two configurations (see
the
Configuration classes
as selected ports. Therefore, you must ensure that all member ports have the same port attributes and
class-two configurations as the reference port. The other settings only need to be configured on the
aggregate interface, not on the member ports.
Use the command...
display lacp system-id
display link-aggregation
load-sharing mode [ interface
[ bridge-aggregation }
interface-number ] ]
display link-aggregation
member-port [ interface-list ]
display link-aggregation
summary
display link-aggregation
verbose [ bridge-aggregation }
[ interface-number ] ]
reset lacp statistics [ interface
interface-list ]
reset counters interface
[ bridge-aggregation }
[ interface-number ] ]
section) as the reference port (see the
1-14
Remarks
Available in any view
Available in any view
Available in any view
Available in any view
Available in any view
Available in user view
Available in user view
Reference port
section) can operate