Restarting A Map; Displaying Map Information; Displaying Map Configuration Information - 3Com 3CRWX120695A, 3CRWX440095A Configuration Manual

Restarting a MAP

Displaying MAP
Information
Displaying MAP
Configuration
Information
WX1200# display ap config 2
Port 2: AP model: AP2750, POE:
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode:
tx pwr: dynamic, profile: default
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
To restart a MAP access point, use the following command:
reset {ap port-list | dap dap-num}
Use the reset ap command to reset a MAP access point configured on a
MAP access port. Use the reset dap command to reset a Distributed
MAP.
When you enter one of these commands, the MAP access point drops all
sessions and reboots.
Restarting a MAP access point can cause data loss for users who are
currently associated with the MAP.
You can display the following MAP information:
MAP and radio-specific configuration settings
List of Distributed MAPs configured in the Mobility Domain
List of Distributed MAPs that are not configured on a WX switch
Connection information for Distributed MAPs
Service profile information
Radio profile information
Status information
Statistics counters
To display configuration information, use the following commands:
display ap config [port-list [radio {1 | 2}]]
display dap config [dap-num [radio {1 | 2}]]
The command lists information separately for each MAP access point.
To display configuration information for a MAP access point on WX port
2, type the following command:
enable, bias: high, name: MAP02
enabled, channel: dynamic

Displaying MAP Information

159