System:beeper:error[:State]; System:communication:abort - Tektronix Keithley 2281 Series Reference Manual

Model 2281S-20-6 DC Power Supply and Battery Simulator Reference Manual

:SYSTem:BEEPer:ERRor[:STATe]

This command allows you to turn the beeper on or off.
Type
Command and query
Usage
:SYSTem:BEEPer:ERRor[:STATe] <state>
:SYSTem:BEEPer:ERRor[:STATe]?
<state>
Details
This command enables or disables the beeper for error messages. When enabled, a beep signals
that an error has happened.
Example
:SYSTem:BEEPer:ERRor ON
Also see
:SYSTem:KCLick

:SYSTem:COMMunication:ABORt

This command causes the remote control to transfer to the present interface.
Type
Command only
Usage
SYSTem:COMMunication:ABORt
Details
The instrument supports the following interfaces:

USB

LAN

GPIB

LXI
Only one interface may be connected at a time. When one interface is active, all the others are
blocked.
When this command is sent by one of the interfaces, the present active interface is blocked, and the
interface that sends SYST:COMM:ABOR becomes active.
077114601 / March 2019
Affected by
Recall settings
Instrument reset
Power cycle
Disable the beeper: OFF or 0
Enable the beeper: ON or 1
(on page 7-170)
Affected by
Not applicable
Section 7: SCPI command reference
Where saved
Save settings
Enable the error beeper.
Where saved
Not applicable
Default value
1 (ON)
Default value
Not applicable
7-163