Trigger Subsystem; Trigger[:Sequence[N]]:Count - Tektronix Keithley 2281 Series Reference Manual

Section 7: SCPI command reference

TRIGger subsystem

The commands in this subsystem configure and control the trigger model for trigger layer.

:TRIGger[:SEQuence[n]]:COUNt

This command sets the number of times to repeat the trigger event.
Type
Command and query
Usage
:TRIGger[:SEQuence[n]]:COUNt <count>
:TRIGger[:SEQuence[n]]:COUNt?
:TRIGger[:SEQuence[n]]:COUNt? DEFault
:TRIGger[:SEQuence[n]]:COUNt? MINimum
:TRIGger[:SEQuence[n]]:COUNt? MAXimum
[n]
<count>
Example
:TRIG:COUN 4
Also see
:ARM[:SEQuence[n]]:COUNt
Trigger model
7-198
Model 2281S-20-6 DC Power Supply and Battery Simulator Reference Manual
Affected by
Recall settings
Instrument reset
Power cycle
Channel number: For single-channel instruments, the value is 1
The number of times to repeat the trigger: 1 to 2500
(on page 7-21)
(on page 3-30)
Where saved
Save settings
Set the trigger count to four.
Default value
1
077114601 / March 2019