Shipping Components - Rockwell Automation MagneMotion QuickStick HT User Manual

Table of Contents

Advertisement

Maintenance
Shipping
kg
1.
Turn off and disconnect all power and communication connections as detailed in
Shut-down on page
2.
Make sure that the component has been properly decontaminated following the decon-
tamination procedures for the facility. Follow all facility, local, and national proce-
dures for the disposal of any hazardous materials.
3.
When shipping individual components, remove all components to be shipped (see
Transport System Installation on page 179
components) and see

Shipping Components

1.
Each component must be wrapped, bagged, and packed following standard packing
procedures.
2.
Using the container that the component was originally shipped in, set the component
into the container and secure using the supplied packing material.
3.
Close the shipping container and secure.
4.
Make sure that the container is properly labeled (This End Up, Caution – Heavy, and
so on) and all shipping documents are attached to the outside of the container.
5.
When shipping to MagneMotion, make sure that the RMA number is clearly visible on
the outside of the container.
312
LIFTING HAZARD: The QuickStick HT motors can
weigh as much as 41.5 kg [91.5 lb]. Failure to take the proper
precautions before moving them could result in personal
injury.
Use proper techniques for lifting and safety toe shoes when
moving any QuickStick HT components.
261.
Shipping Components on page
MAGNETIC FIELD HAZARD: When shipping magnet
arrays, make sure that the shipping container properly iso-
lates the magnet arrays or identifies the Magnetic Field Haz-
ard.
Rockwell Automation Publication MMI-UM007F-EN-P - September 2020
and reverse the sequence to remove the
312.
MagneMotion

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MagneMotion QuickStick HT and is the answer not in the manual?

Table of Contents