Rockwell Automation MagneMotion QuickStick HT User Manual page 209

DC-bus Connection System
The DC-bus connection system is required and comprised of these two components:
• DC-bus links that are inserted between modules to extend the DC-bus from one mod-
ule to another.
• DC-bus end-caps that are inserted into the first and last modules to cover the exposed
DC-bus connector on both ends of the bus.
24V Input Power Connection System
The optional 24V input power connection system always feeds 24V DC from left to right and
is comprised of three components:
• The 24V input wiring connector that plugs into the 2198-Pxxx DC-bus power supply
or the first module that is supplied by the 24V external power.
• 24V DC T-connectors that plug into the modules downstream from the power supply
or the first module that is supplied by the 24V external power where the 24V control
power is shared.
• Bus bars that connect between drive modules to extend the 24V control power from
one drive module to another.
Wiring the Power Connections
NOTE: The AC power connections are made later (see
See Input Power Configurations for Kinetix 5700 Power Supplies and Ground
Screw/Jumper Settings in the Kinetix 5700 Servo Drives User Manual,
2198-UM002.
See Electrical Wiring on page 73
sized.
See Table 4-32 on page 154
make sure that each chain of motors does not exceed the rated output of the power
supply.
1. Connect a DC Power-bus connector to the terminals on the power supply and to the
first QSHT 5700 inverter.
• Make sure that the power supply is properly grounded (see the Kinetix 5700
Servo Drives User Manual, 2198-UM002).
• See the Kinetix 5700 Servo Drives User Manual,
tion.
2. For each inverter, connect a DC Power-bus connector to the terminals on the inverter
and to the next QSHT 5700 inverter.
NOTE: It is not necessary to connect all motors on a path to the same power supply
QuickStick HT User Manual
when connecting the power cables to the motors to
or to connect a power supply to only one path.
Rockwell Automation Publication MMI-UM007F-EN-P - September 2020
Transport System Installation
Facilities Connections on page
to make sure that all power wiring is properly
2198-UM002
Installation
214).
for bus installa-
209