Miscellaneous Operating Tasks; Oven Temperature Control - Stratasys Fortus 360mc User Manual

MISCELLANEOUS OPERATING TASKS

OVEN TEMPERATURE CONTROL

The oven modeling temperature is determined by the loaded material type. It is controlled by the system
software and cannot be modified. However, the operator does have control of some oven temperature functions.
•
Set Oven to Build Temp
loaded material.
•
Cool Down Oven to
material.
•
Auto Cool Oven
is reached - this takes about 30 minutes. This option acts as an energy saver when PC, PC-ABS, or
PPSF materials are being used. It also helps to prevent part cracking when building large, thick parts
with PPSF. Auto-cool down can be set to
•
After Next Job
automatically reset to OFF.
•
After Every Job
material's standby temperature.
: After every job is built, the oven temperature will stay at the material's build temperature.
•
OFF
To control oven temperature:
1. From the Main Menu select
2. Select
Temp Control
3. Select one of the temperature parameters (as shown below) and press ENTER.
- The oven will heat to the system controlled build temperature for the
- The oven will cool to system controlled standby temperature for the loaded
- The oven will cool incrementally until the system controlled standby temperature
: After the next job is built and auto-cooled, the auto-cool down mode will
: After every job is built and auto-cooled, the oven temperature will stay at the
Operator Control
Build Job..
>Operator Control..
Modeler Status..
Maintenance..
and press ENTER.
Unlock Door <E>
Load/Unload Mtl..
Change Tips/Mtl..
Calibrate..
Set Oven to Build Temp:
Cool Down Oven to:
>Auto Cool Oven:
,
After Next Job After Every Job
and press ENTER.
|*Tips: Model T16
|* Support T16
|>Temp Control..
| Move Head/Stage..
145°C <E>
85°C <E>
OFF <E>
58
, or
OFF.