Miscellaneous Operating Tasks; Oven Temperature Control - Stratasys Fortus 360mc User Manual

Miscellaneous Operating Tasks

Oven Temperature Control

The oven modeling temperature is determined by the loaded material type. It is
controlled by the system software and cannot be modified. However, the
operator does have control of some oven temperature functions.
•
Set Oven to Build Temp
temperature for the loaded material.
•
Cool Down Oven to
temperature for the loaded material.
•
Auto Cool Oven
controlled standby temperature is reached - this takes about 30 minutes. This
option acts as an energy saver when PC, PC-ABS, or PPSF materials are being
used. It also helps to prevent part cracking when building large, thick parts
with PPSF. Auto-cool down can be set to
Job
•
After Next Job
down mode will automatically reset to OFF.
•
After Every Job
temperature will stay at the material's standby temperature.
•
OFF
build temperature.
To control oven temperature:
1.
From the Main Menu select
2.
Select
3.
Select one of the temperature parameters (as shown below) and press ENTER.
- The oven will cool to system controlled standby
- The oven will cool incrementally until the system
, or
OFF.
: After the next job is built and auto-cooled, the auto-cool
: After every job is built and auto-cooled, the oven
: After every job is built, the oven temperature will stay at the material's
Build Job..
>Operator Control..
Modeler Status..
Maintenance..
and press ENTER.
Temp Control
Unlock Door <E>
Load/Unload Mtl..
Change Tips/Mtl..
Calibrate..
Set Oven to Build Temp:
Cool Down Oven to:
>Auto Cool Oven:
- The oven will heat to the system controlled build
After Next Job
Operator Control
|*Tips: Model T16
|* Support T16
|>Temp Control..
| Move Head/Stage..
145° C <E>
85° C <E>
OFF <E>
4-35
,
After Every
and press ENTER.