Miscellaneous Operating Tasks; Oven Temperature Control - Stratasys FORTUS 360mc Manual

FORTUS 360mc/400mc and FDM 360mc/400mc User Guide

Miscellaneous Operating Tasks

Oven Temperature Control

The oven modeling temperature is determined by the loaded material type. It
is controlled by the system software and cannot be modified. However, the
operator does have control of some oven temperature functions.
•
Set Oven to Build Temp
controlled build temperature for the loaded material.
•
Cool Down Oven to
standby temperature for the loaded material.
•
Auto Cool Oven
system controlled standby temperature is reached - this takes
about 30 minutes. This option acts as an energy saver when PC,
PC-ABS, or PPSF materials are being used. It also helps to prevent
part cracking when building large, thick parts with PPSF. Auto-
cool down can be set to
OFF.
•
After Next Job
auto-cool down mode will automatically reset to OFF.
•
After Every Job
oven temperature will stay at the material's standby temperature.
: After every job is built, the oven temperature will stay at the
•
OFF
material's build temperature.
To control oven temperature:
1.
From the Main Menu select
Build Job..
>Operator Control..
Modeler Status..
Maintenance..
2.
Select
Temp Control
Unlock Door <E>
Load/Unload Mtl..
Change Tips/Mtl..
Calibrate..
3.
Select one of the temperature parameters (as shown below) and press
ENTER.
Set Oven to Build Temp:
Cool Down Oven to:
>Auto Cool Oven:
- The oven will heat to the system
- The oven will cool to system controlled
- The oven will cool incrementally until the
After Next Job
: After the next job is built and auto-cooled, the
: After every job is built and auto-cooled, the
Operator Control
|*Tips: Model T16
|*
and press ENTER.
|>Temp Control..
| Move Head/Stage..
145° C <E>
85° C
OFF
,
After Every Job
and press ENTER.
Support T16
<E>
<E>
, or
4-35