Configure Arrayloc - Christie Matrix StIM-WQ User Manual

Configure ArrayLOC

Select the projector-to-projector communication network configuration for all Ethernet messages
related to ArrayLOC functions, including ArrayLOC messages, and BCLOC messages. Make sure all
projectors in an array are operating on the same network, either the Control Network or the
ArrayLOC Network. See
1. From the Main menu, select ArrayLOC >
ArrayLOC Configuration.
2. From the ArrayLOC Network drop-down list
select from ArrayLOC Network or Control
Network.
3. Assign an ArrayLOC Group to the array. Only
projectors in the same ArrayLOC group will
automatically achieve a common gamut and
brightness.
4. Use the Synchronized keys, Test Pattern, Color Enable option to set the projector to listen
for remote keystrokes through the ArrayLOC network and the master projector. All synchronized
projectors respond to the same keystrokes. Double key strokes may not register correctly, use
alternate key commands instead.
A synchronized projector automatically starts listening to its IR receiver if the master projector
becomes unavailable, for example if it goes into Standby mode. Independent indicates that the
projector listens to its own IR remote receiver. It is the default option. Change this setting for
each projector individually.
ArrayLOC network communication overrides RS-232 serial communication for keys.
5. Set fields 4 to 7 to Synchronized when you want to sync the particular feature for all the
projectors in the ArrayLOC group. Use the Independent setting to make changes to each
projector individually independent of the master projector. The default setting for each selection
is Synchronized.
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)
ArrayLOC Network Configuration on page 19.
ArrayLOC
55