Configure Gpio - Christie Matrix StIM-WQ User Manual

GPIO Port

Configure GPIO

The GPIO connector can be configured to automate any number of events using the serial command
code GIO. See General Purpose Input/Output (GIO)
or output depending on the desired outcome. Configure the pin as an input if you want the projector
to respond to something the device does and as an output if you want the external device to respond
to an action taken by the projector. For example, configure the pin as an output if you want the
lighting in a room to automatically dim when the projector is powered On. By using the GIO
command, you can also set the state of each output pin as high or low. By default, the state of each
pin is high. The voltage applied to pins in the high state is +3.3 V. A low state (or value of 0) will be
read on an input pin if the circuit attached to the pin is open. A high state (or value of 1) will be read
on an input pin if the circuit attached to the pin is shorted to ground. This corresponds to a switch
closing event.
Pin Open (0 or L)
Pin Closed (1 or H)
Example
Turn room lighting on when the projector is powered Off (assumes a control/automation unit is
configured to power the lights On when pin 2 of its input goes high).
The strings in the commands refer to pins 2, 3, 4, 6, 7, 8, 9 in order from left to right.
(GIO+CNFG "OOOIIII")
(GIO+STAT "HLXXXXX")
Query Command
(GIO+STAT)
(GIO+STAT "HLLHLLH")
(GIO+CNFG)
(GIO+CNFG "IIIOOOO")
124
on page 99. Each pin is defined as either an input
Set pin #2, 3 and 4 configuration to output and pin 6, 7, 8 and 9 to input.
Set pin #2 to high, pin 3 to low and the state of all other pins unchanged.
Request the state of all pins.
Reply of pin states - H means pin is high, L means pin is low.
Request the configuration of all pins.
Reply of pin configurations - pins #2, 3 and 4 are inputs, pins 6, 7, 8 and 9
are outputs.
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)