Inputs 1 And 2; Gpio; Arrayloc Network - Christie Matrix StIM-WQ User Manual

Inputs 1 and 2

Native WQ is required in order to receive a valid DVI-D signal.
Use Inputs 1 and 2 to connect the main and secondary input sources. See
The LEDs assigned to each input indicate the following:
S

GPIO

The GPIO connector provides a method of interfacing a wide range of external
I/O devices. See GPIO
configuration and how to program the GPIO.

ArrayLOC Network

The ArrayLOC Network connector provides a method of interfacing multiple projectors in an array to
manage preliminary color setup. For details, see
ArrayLOC on page 49.
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)
S indicator (signal)
Green: Indicates valid DVI-D source
signal.
F
Red: Indicates an invalid source signal.
Check the connection and make sure the
source is correct.
Off: Indicates no signal detected on DVI
port.
on page 13 and GPIO Port
Green: Indicates the input is selected.
Yellow: Indicates which of the 2
inputs is being used as the secondary
input.
Off: Indicates no input is selected.
on page 123 for complete details on pin
ArrayLOC Network Configuration
Setup Procedures
Select Inputs on page 40.
F indicator (function)
on page 19 and
13