Login To Webui - Christie Matrix StIM-WQ User Manual

Login to WebUI

1. Open your web browser and enter the IP address (in the address bar) assigned to your projector.
The factory default IP address is 192.168.1.89. To change the default use the NET serial
command through RS-232. See
2. Select the appropriate language from the Language drop-down list, located in the upper left-
hand corner.
3. Enter your user name and password. Both entries are case-sensitive.
4. Click the Login button. The Main window appears.
1
2
3
4
5
6
7
1 Status bar
2 Primary tabs
3 Main Input drop-down list
4 Main Signal State (read-only)
5 Secondary Input drop-down lists
6 Secondary Signal State (read-only)
7 Secondary tabs (specific to a primary tab) located along the bottom of the Main page.
8 Status indicator display
9 Power On/Off
10 Shutter Open/Close (powers LEDs On and Off to simulate shutter operation).
11 Projector information (read-only)
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)
Network Setup (NET) on page 108.
Description
8
9
10
11
25