Network Setup For External Communications; Ethernet (Recommended) - Christie Matrix StIM-WQ User Manual

Network Setup for External Communications

To complete the projector network setup you will also need to connect the projectors
together for ArrayLOC communication and functions. See
on page 19.

Ethernet (recommended)

In the Ethernet network the controller communicates with each projector separately.
Recommended for network administrators only.
1. Connect a standard CAT5 Ethernet cable between the controller (or Ethernet hub) and the
Control Network port on the projectors input panel.
2. From the WebUI, set the IP address in Configuration > Communications > Ethernet
Settings. See
3. From the WebUI, set network routing to Separate in Configuration > Communications. See
Communications
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)
CAT5
CAT5
to other
Ethernet devices
Communications on page 61.
on page 61.
ArrayLOC Network Configuration
CAT5
CAT5
Setup Procedures
15