Ethernet Settings - Christie Matrix StIM-WQ User Manual

Configure the Display
All Joined
All messages reach all ports, regardless of type. In the case of multiple Ethernet sessions, input on
one Ethernet session will be relayed to all other Ethernet sessions, as well as to the RS-232 and RS-
422 ports.

Ethernet Settings

Recommended for Network Administrators only.
To access the Ethernet Settings window select Configuration > Communication > Ethernet
Settings from the Main menu.
IP Address
Enter a valid and unique IP address for use on the network
to which the projector is currently connected. This address
will overwrite any previous IP address such as the projector
factory-defined default. It takes approximately 10 seconds
for the projector to respond to its new address.
TCP Port
On some Ethernet networks, firewall restrictions may require that the port number of the projector
be changed from its default of 3002. If so, enter a new valid port number here. It is highly
recommended not to use a port number below 1000, as these ports are typically reserved for and
used by common IP applications.
Subnet Mask
Subnet Mask determines the subnet mask for the IP address and must be set manually.
Gateway
This is the IP address of the gateway used to reach any non-local IP addresses; it must be set
manually.
Host Name
Set the hostname for the device.
Domain Name
Set the domain for the device.
MAC Address
Displays the MAC address of the projector (read-only).
Matrix StIM™ WQ/SIM WQ User Manual 63
020-100883-01 Rev. 2 (06-2013)