Fan Assist; Change Date And Time; Communications; Serial Options - Christie Matrix StIM-WQ User Manual

Configure the Display
non-visible (IR) light. In this mode any visible light from the projector can noticeably reduce image
contrast as seen through NVG devices.

Fan Assist

If necessary, use the slide bar to increase projector fan control. An increase to this setting will make
the fans quicker to react and run at a higher intensity. The default setting is 0. Increase the setting
when operating in high ambient conditions. This may help ease thermal problems in such
environments. Fan assist increases noise levels.

Change Date and Time

To change the current year-month-day, hour-minute-second go to Configuration > Date and Time.
Changes made reset the projector real-time clock.

Communications

The Communications menu allows you to define and
control how single or multiple projectors are linked
with each other and with a controlling device. See
Serial Communication on page 77. To access this
menu select Configuration > Communications
from the Main menu.

Serial Options

Baud Rate
Determines the speed of communication to and from
the projector on the RS-232 or RS-422 links. The
maximum rate for RS-232 is 115200; for RS-422 it
is 19200. Set the baud rate to match that of your
controlling device, such as your PC. See the
documentation for the controlling device to
determine the baud rate. In an existing network of
projectors, if you discover that a projector has a different baud rate, use the pull-down list and select
the correct baud rate. Serial communication is always 8 data bits, no parity.
Matrix StIM™ WQ/SIM WQ User Manual 61
020-100883-01 Rev. 2 (06-2013)