Error Codes - Christie Matrix StIM-WQ User Manual

Error Codes

If the status display window shows any of the codes in the table below you may need a Christie
accredited service technician to repair the component identified by the error code.
Error codes are displayed in a 3-phase format:
• First 2 digits represent the component or error category
• Second 2 digits represent the specific problem
• Display off
This cycle repeats. The LED will be red while the error code is displayed.
Acknowledge and clear the error by pressing Exit twice. If the error recurs then try resetting the
projector by powering Off and On again. Contact the dealer if the problem persists or if you see a
code not listed in the table below.
Error Code
(7-segment
display)
Light Engine
LE
Link
LI
Temperature Sensor
SP
41
42
43
44
45
46
47
48
49
50
51
52
53
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)
Light engine error
Engine error (typically during power-up)
Link down
Communication link status (internal communication error)
Temperature sensor error (index number following tracks SST response IDs)
Air inlet error
Power supply 0
Power supply 1
FCB board
QD board
DMD
QD FPGA
QPC board
QPC CPLD
QPC FPGA
Red SAM
Green SAM
Blue SAM
Description
Error Codes
71