Connect To Power; Disconnect Power - Christie Matrix StIM-WQ User Manual

Setup Procedures

Connect to Power

013- 102318- 01 R EV 02
Do not operate if the AC supply and cord are not within the specified voltage and power
range. The North American rated line cord is supplied with this projector. For all other
regions, use only a regionally approved line cord, power plug and socket. Do not use a
damaged line cord. Failure to comply could result in death or serious injury.
In Norway, for IT power distribution systems, a dedicated protected earth wire must be
installed on the projector before it can be connected to power. The dedicated earth wire
must be installed by a Christie accredited service technician. To connect the projector to an
IT power distribution system connect the building ground to the internal ground lug behind
the AC input inside the projector. It is recommended that you run the connection through
the louvers on the projector. Failure to comply may result in equipment damage.
The appropriate regional line cords are shipped separately.
1. Connect an approved line cord to the projector AC receptacle. Make sure the security clip is
latched onto the cord.
2. Connect the 3-pronged end of the line cord to a grounded AC outlet. The outlet must be near the
equipment and easily accessible.
3. Flip the power switch on the back of the projector. The projector takes approximately 2 minutes
to initialize. The status light on the input panel turns yellow.
4. Press Power, and then the up arrow from the IR remote.
Or:
5. From the WebUI select Power > On from the Main tab.
6. Press an input key on the IR remote to select and display the image for the connected source.

Disconnect Power

Do not flip the main Power switch to the Off position, or disconnect the projector until the
cooling fans have stopped. Failure to comply may result in equipment damage.
1. Press Power, and then the down arrow from the IR remote.
Or:
2. From the WebUI select Power > Off from the Main tab.
3. After the internal cooling fans stop, flip the main power switch to the Off position.
4. Disconnect the line cord from the wall outlet.
14
Always power down and disconnect/disengage power before servicing or cleaning
Failure to comply could result in death or serious injury.
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)