Navigate The Webui - Christie Matrix StIM-WQ User Manual

Navigate the WebUI

Navigate the WebUI
This section describes the controls and switches used for projector operation once it is properly
installed and configured. The Matrix StIM™ WQ projector can be controlled remotely, typically at a
controller such as a PC, via a WebUI on an Ethernet Network. If there are concerns about network
security, run the WebUI on a local area network only and install a firewall. Users are prompted to log
in upon start-up. Use admin for both the user name and password. For an overview of the menus,
see WebUI Menu Tree
• After 15 minutes of inactivity, the projector closes the menu and returns to the
• To avoid losing your web connection, it is recommended that you navigate using the
From the WebUI:
• Select and setup an active input source.
• Manipulate the appearance of video content (Gamma, AccuFrame, ArrayLOC, InfraRGB).
• Display a test pattern.
• Configure the display (image orientation, calibration).
• View system information and alerts.
26
on page 75.
presentation.
application interface and related functionality detailed in this section rather than use the
web browser's navigation tools.
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)