Installation Procedures; Unpack The Projector - Christie Matrix StIM-WQ User Manual

Installation Procedures

Installation Procedures

Unpack the Projector

The projector should be lifted by 2 people. Use the designated handles to help lift and
support the projector. Use a stable cart to transport the projector. Failure to comply could
result in minor or moderate injury.
Do not place the projector onto a surface with the line cord retainer side down. Failure to
comply may result in damage to the line cord retainer.
Christie recommends that the packaging material for at least 1 projector is saved in case
one needs to be shipped for service.
The projector is shipped assembled with the projection lens shipped separately. Install the lens once
the projector is fully assembled and in its final position. See
1. Remove the line cord from the packaging.
2. Remove the top foam from the box.
3. Open the bag and lift the projector up using the 2 handles. It is recommended that 2 people
remove the projector, each holding onto a handle.
4. Rotate the projector 90° and place on a flat surface.
6
Install the Lens
Line cord
Top foam
Handles
Place on a flat surface in the orientation shown.
on page 8.
Do not place the projector onto a surface
with the line cord retainer side down.
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)