Active Projector (APJ)
APJ
Input
CONTROL GROUP:
Description
Temporarily enable or disable the IR and wired keypad Inputs to a specific projector in a network of projectors.
When a projector is disabled, the only key that works is PROJ. The next time the projector is powered up again, it
will revert to fully enabled. The built-in keypad will always be fully functional. This control does not overwrite the
Front IR, Back IR and Wired Keypad settings.
Subcode
<No Subcode >
Examples:
(APJ 1) Projector is active (keypads are enabled).
(APJ 0) Projector is not active (keypads are temporarily disabled).
(APJ?) Is the projector keypad active or not.
Auto Power Up (APW)
APW
Preference
CONTROL GROUP:
Description
When the A/C switch is turned ON, the projector will automatically change from Stand-by Mode to Power ON
Mode. The projector will switch the lamp(s) on without waiting for further user actions.
Subcode
<No Subcode >
Examples:
(APW 0) Projector will remain in Standby Mode until the user presses the power key.
(APW 1) Projector will auto power up when A/C power is switched On.
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)
Power Down
SUBCLASS:
Description of Use
Set 0 to temporarily disable keypad access to this projector.
Power Down
SUBCLASS:
Description of Use
Set to 1 to enable.
Serial Command Reference
Operator
ACCESS LEVEL:
Operator
ACCESS LEVEL:
91