Color Enable (Cle); Data Logging (Dlg) - Christie Matrix StIM-WQ User Manual

Color Enable (CLE)

CLE
Unsaved
CONTROL GROUP:
Description
This control allows the three primary colors (red, green, and blue) to be turned ON or OFF separately. It is used
to look at the colors one at a time or in pairs when doing convergence, light measurements, etc. The list of values
for this command are:
0 = White 
1 = Red 
2 = Green 
3 = Blue
Subcode
<No Subcode >
Examples:
(CLE 1) Display red portion of image only. 
(CLE 5) Display green and blue portion of image only. 
(CLE 0) Display image normally (all primaries).

Data Logging (DLG)

DLG
Preference
CONTROL GROUP:
Description
Set data logging level. 
0 = Minimal logging of activities. Logging system errors, warnings and 'events' (i.e. power ON/OFF, lamp ON/
OFF, user login/logout). 
1 = Normal logging. Most activities logged - errors, warnings, events, and other info. 
2 = Debug logging. All activities are logged.
Subcode
<No Subcode >
Examples:
(DLG1) Set current logging level to 1. 
(DLG?) Get current logging level. Response is (DLG!001).
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)
Power Up
SUBCLASS:
4 = Yellow 
5 = Cyan 
6 = Magenta
Power Down
SUBCLASS:
ACCESS LEVEL:
Description of Use
ACCESS LEVEL:
Description of Use
There are 3 levels for data logging.
Serial Command Reference
Operator
Operator
95