Accuframe (Acf); Address (Adr) - Christie Matrix StIM-WQ User Manual

Serial Command Reference

Accuframe (ACF)

ACF
Preference
CONTROL GROUP:
Description
Configure AccuFrame parameters. Used to reduce motion artifacts for simulation systems, specifically for night
scenes. Will reduce brightness. The values represent draw-time in microseconds for RGB and IR. The remainder of
the time in the frame will be dark time. Four preset values are provided and these correspond with particular
InfraScene modes selected through IFS+ISEQ mode. In the subcodes listed below replace x with the values 0 1 2
3 or C, meaning of which is:
0 = InfraScene off (IFS+SLCT 0) 
1 = InfraScene continuous (IFS+SLCT 1)(IFS+ISEQ 1) 
2 = InfraScene interleaved RGB+IR (IFS+SLCT 1)(IFS+ISEQ 4) 
3 = InfraScene interleaved RGB RGB (IFS+SLCT 1)(IFS+ISEQ 5) 
C = Current table. This subcode is an alias to the currently selected table
Subcode
SLCT
RGxT
IRxT
RGAT
IRAT
Examples:
(ACF+SLCT 1) Enable AccuFrame.
(ACF+RGCT 10000) Set RGB draw time to 10ms.

Address (ADR)

ADR
Preference
CONTROL GROUP:
Description
Set/Query Device Address on ASCII Protocol network. Required only for RS-232 connections that are daisy
chained to allow directed messages.
Subcode
<No Subcode >
Examples:
(65535 ADR 0) Set all devices to address 0. 
(0 ADR 5) Set first device at address 0 to address to 5. 
(65535 1001ADR?) Query address for all devices and return results to address 1001. 
Expected response to previous query (01001 00005ADR!005).
90
Power Up
SUBCLASS:
Description of Use
Enable AccuFrame.
Requested draw time for RGB. Specified in microseconds.
Requested draw time for IR. Specified in microseconds.
Actual RGB draw time fulfilled by system. In microseconds.
Read only.
Actual IR draw time fulfilled by system. In microseconds. Read
only.
Power Down
SUBCLASS:
Description of Use
Valid Address range is 0 to 999. Reserved broadcast address is
65535.
Operator
ACCESS LEVEL:
Operator
ACCESS LEVEL:
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)