Serial Command Reference; Array Bright Color Loc (Abl) - Christie Matrix StIM-WQ User Manual

Serial Command Reference

Array Bright Color LOC (ABL)

ABL
CONTROL GROUP: Preference
Description
This command is used to set parameters that control how the Array Bright/ColorLOC feature operates. From this
control you enable the mode in which you want to operate the feature: target brightness, target gamut, update
intervals, and other miscellaneous parameters. This command is persistent, and will save the "synchronize to this
projector" operation between power-ups.
Projector Color Adjustment (PCA)
See
Target Color Space (TCS)
See
Target White Point (TWP)
See
Subcode
ABI+DEVC
ABL+DEVC 0
ABL+DEVC 1
MODE
BRGP
BRTG
MINB
MING
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)
SUBCLASS: Power Up
on page 110.
on page 119.
on page 121.
Description of Use
Use to set the ArrayLOC networking device.
Set the networking device to the ArrayLoc network. The second
Ethernet port on the projector will be used to broadcast
ArrayLoc packets.
Set the networking device to the Control network. The first
Ethernet port on the projector will be used to broadcast
ArrayLoc packets. This port is also use to control the projector
over the network.
Enable Array Bright/ColorLOC:
0 = Disabled
1 = Enabled
Brightness Group. Identifies a subset of all projectors in the
array to be used in the Array BCLOC algorithm. May be used to
provide multiple groups of projectors with different color
targets. (0-9999)
Brightness Target. Sets the target brightness that the
projectors in the array brightness group should meet. 
(Range is 0-40,000)
Minimum Brightness. Sets the minimum brightness, as a
percentage of target brightness, that the projector will display
if it is capable. (Range is 0-100%)
Minimum Gamut. Sets the minimum gamut, as a percentage of
the target gamut, that the projector will display if it is capable.
(Rang is 0-100%)
Serial Command Reference
ACCESS LEVEL: Operator
87