Select Inputs - Christie Matrix StIM-WQ User Manual

Select Inputs

Select Inputs
You can use the IR remote to setup your inputs; however, Christie recommends that inputs
are setup through the WebUI.
An input is an input source physically connected to the projector. Input describes the source signal to
which it is connected. See
sources to the projector.
1. From the Main menu, select Input &
Switching.
2. From the Main Input drop-down menu
specify the source of the image. Select from
Input 1 and Input 2.
3. If the projector(s) will be operating with
InfraScene, the source of the image for the
secondary input must be specified through the
Secondary Input drop-down menu.
• To quickly and easily swap your inputs select Swap Main and Secondary Inputs.
• To adjust the gamma settings for the secondary input select Secondary Image Settings.
4. Frame Locking is enabled by default. This feature is used to select how the projector controls
the output frame timing based on the input signal. When set to Frame Lock, output image
frames are locked to the input if possible. When locked, the output is always locked to the main
input. When working with 2 inputs you can select input 2 as the lock source for the output by
selecting Frame Lock Secondary. See
40
Connect a Source
Adjust Gamma Settings
See
on page 12 for a full explanation of how to connect
on page 57.
Control Frame Locking on page 59.
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)